 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| KOA SPEER ELECTRONICS, INC. SS-192 R4 AHA 12/19/03 Capacitor/Resistor Chip Networks Type CR2A10Y 1. Scope This specification shall be applied to CR chip networks CR2A10Y produced by KOA Corporation. CERTIFIED 2. Related Standard JIS C 5102 (1994) JIS C 5202 (1994) JIS C 6429 (1991) JIS C 0806 (1990) Test method of fixed capacitors for use in electronic equipment. Test method of fixed resistors for use in electronic equipment. Fixed Multilayer Ceramic Chip capacitors for use in electronic equipment. Packaging of electronic components on continuous tapes (surface mounting devices). 3. Dimensions 3-1 Dimensions C C 411 B P D L A D W T D D A unit: inches (mm) L W C D T .157 .008 .083 .008 .012 .008 .016 .006 .028 .004 (4.0 0.2) (2.1 0.2) (0.3 0.2) (0.4 0.15) (0.7 0.1) A .02 (0.5 Ref.) B .006 (0.15 Ref.) P .031 (0.8 Ref.) PAGE 1 OF 8 Bolivar Drive I P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 3-2. Circuit Schematic 10 9 8 7 3-3. Structure 1 3 1 Alumina Ceramic 2 Passivation 3 Ni & Solder Plating 1 6 411 2 3 4 5 2 4. Type Designation The type designation shall be the following form: CR Style 2A10 Chip Size Y Circuit TE Packaging xxxM/ xxxJ Capacitance Tolerance/Resistance Tolerance 3 Digit Numbers +1 for Resistance Tolerance for each Ex: 270M/510J CR Chip Networks .157" x .083" 4.0 x 2.1 mm TE: Embossed Taping No Designation: Bulk 5. Rating Operating environment -25C ~ +85C Capacitor Item Capacitance Measuring Condition Voltage Rating Capacitance Tolerance Temperature Coefficient Dissipation Factor Insulation Resistance Dielectric Withstanding Voltage Operating Temperature Range Capacitance Range Capacitor Rating 1 KHz 10% (1 Vrms 0.2V) 25V (DC) 20%/ 30% +20%/-55% 3% maximum Resistor Item Power Rating Maximum Working Voltage Maximum Overload Voltage Temperature Coefficient (-25C ~ +85C) Resistor Tolerance (at 1 KHz 1.0 Vrms) Operating Temperature Range Resistor Rating 0.063 W 7.9 V 15.8 V 200 ppm/C 5% + 70C -25C to +85C 22, 47,100, 220, 470, 1K, 47K PAGE 2 OF 8 Bolivar Drive I 1,000 M minimum Rating Ambient Temperature 62.5V DC 5 sec. 50 mA charge -25C to +85C 22pF, 47pF, 100pF Resistor Range P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 5-2 Rated Voltage The maximum value DC voltage capable of being applied continuously to a resistor at the rated ambient temperature. Rated voltage shall be calculated from the following formula: Where: E = Rated voltage (V) P = Rated power (W) R = Nominal resistance () The rated voltage is limited to the maximum working voltage. Power Derating Curve Percent Rated Wattage (%) 120 100 80 60 40 20 0 -30 -20 -10 0 10 20 30 40 50 60 70 80 90 Ambient Temperature (C) E= PxR 6. Marking 6-1 Apply a mark of 1st terminal for a position of 1st terminal. 6-2 Marking Code Type CR2A10YTE220/220J CR2A10YTE220/470J CR2A10YTE220/101J CR2A10YTE220/221J CR2A10YTE220/471J CR2A10YTE220/102J CR2A10YTE470/220J CR2A10YTE470/470J CR2A10YTE470/101J CR2A10YTE470/221J CR2A10YTE470/471J CR2A10YTE470/102J CR2A10YTE101/220J CR2A10YTE101/470J CR2A10YTE101/101J CR2A10YTE101/221J CR2A10YTE101/471J CR2A10YTE101/102J CR2A10YLTE101M/473J Capacitance (pF) 22 22 22 22 22 22 47 47 47 47 47 47 100 100 100 100 100 100 100 Resistance () 22 47 100 220 470 1K 22 47 100 220 470 1K 22 47 100 220 470 1K 47K Marking Code 120 140 111 121 141 112 220 240 211 221 241 212 420 440 411 421 441 412 443 PAGE 3 OF 8 Bolivar Drive I P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 7. Test Condition Unless otherwise specified, the test shall be performed in accordance with JIS-C-5020 specifying at the temperature of 20 C 15C and at the humidity of 65% 20%. In case doubts arise about the test results, the test shall be performed at the temperature of 20C 2C and at the humidity of 65% 5%. 8. Reliability Test 8-1 Electrical Characteristics No. 1 Item Insulation Resistance Requirement More than 104 M Test Methods Within 2 minutes at DC 25V between terminal and another v 2 Dielectric Withstanding Voltage No evidence of fuming flaming or breakdown 2.5 times maximum rated voltage for 5 seconds with 50 mA maximum charging current v PAGE 4 OF 8 Bolivar Drive I P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 8-2 Mechanical Characteristics No. 1 Item Resistance to Soldering Heat Requirement No evidence of damage C within 20% R within 5% D. F. within 5% I. R. more than 100 M Approximately 95% of the terminal should be covered with new solder No mechanical damage Test Methods Immerse in the solder (H63A) of 260C 5C for 10 1 seconds. Measurement shall be done 24 4 hours at room condition after test. 2 Solderability Immerse in the solder (H63A) of 235C 5C for 3 0.5 seconds. 3 Terminal Strength (Bend test) Specimen shall be soldered on PCB and support by applying strength so that the bending width becomes 3mm. Immerse in the IPA of 20 ~ 25C for 60 10 seconds. 2 hours in each direction of X,Y,Z on PCB at a frequency range of 10-55-10Hz with 1.5mm amplitude. Measurement shall be done 24 4 hours at room condition after test. 4 Resistance to Solvents Vibration No mechanical damage 5 No evidence of damage 8-3 Environmental Characteristics No. 1 Item Temperature cycling Requirement No evidence of damage C within 20% R within 5% D.F. within 5% I.R. more than 100 M No evidence of damage C within 20% R within 5% D.F. within 5% I.R. more than 100 M No evidence of damage C within 20% R within 5% D.F. within 5% I.R. more than 100 M Test Methods 100 cycles between - 40C/30 minutes and +125C/30 minutes. Measurement shall be done 24 4 hours at room condition after test. MIL-STD-202F Method 106 10 cycles Measurement shall be done 24 4 hours at room condition after test. Temperature 40C 2C Humidity 90% ~ 95% 1000 hours DC 50V 1.5 hours ON 0.5 hours OFF Measurement shall be done 24 4 hours at room condition after test. Temperature 70C 2C 1000 hours DC 50V 1.5 hours ON 0.5 hours OFF Measurement shall be done 24 4 hours at room condition after test. PAGE 5 OF 8 Bolivar Drive I 2 Humidity (No Load) 3 Moisture Resistance 4 Load Life No evidence of damage C within 20% R within 5% D.F. within 5% I.R. more than 100 M P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 9. Packaging 9-1 Bulk Packaging 100 pieces chip are packed in a poly bag. The package shall be marked: (1) Type Designation (CR2A10Y) (2) Nominal Capacitance/Nominal Resistance (3 digit/3 digit) (3) Quantity (4) Production Lot. No. (5) Manufacturer's name 9-2 Taping The taping shall be embossed carrier tapes of 12 mm width and 4 mm pitches. The standard quantity per reel shall be 4000 pieces. (1) Carrier Tape P0 P2 oD E F B W T2 T1 2nd Terminal P1 A Tape Running Direction Type CR2A10Y T1 1.15 0.2 A 2.5 0.2 T2 0.25 0.05 B 4.4 0.2 P0 4.0 0.1 W 12.0 0.2 P1 4.0 0.1 E 1.75 0.1 P2 2.0 0.1 (unit: mm) F 5.5 0.1 oD 1.5 0.1 -0 Top tape peeling strength: 10 ~ 55g PAGE 6 OF 8 Bolivar Drive I P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 (2) Reel B D A W (unit: mm) A 178 2.0 B 60 2.0 D 21 0.8 W 10 1.0 (3) Leader and End Tape End tape 300 (+20) (4,000 pieces) Leader tape 150 (+20) 350 (+20) Empty Empty Top tape Tape Running Direction (4) Contents on label (1) (2) (3) (4) (5) (6) Type Designation (CR2A10Y) Nominal Capacitance/Nominal Resistance (3 digit/3 digit) Quantity Customer's code No. Production lot No. Manufacturer's name Manufacturer's name PAGE 7 OF 8 Bolivar Drive I P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. KOA SPEER ELECTRONICS, INC. SS-192 R4 10. Land Pattern Design F G BWA D C L E (unit: mm) C 0.4 D 0.4 E 0.8 F 5.1 G 3.5 L 4.0 W 2.1 A 1.7 B 3.1 11. Soldering 11-1 Reflow Soldering Reflow soldering should be done at 240C for less than 20 seconds. Temperature (C) 300 200 100 150C cooling naturally 60 ~ 120 sec 30 ~ 60 sec 5 ~ 30 sec 200 ~ 240C 1 ~ 4C/sec 1. The melting time of soldering should be as short as possible. 2. After the soldering, allow products to cool naturally. 3. We do not recommend flow soldering to CR Chip Networks, because of concern that a solder bridge occurs due to narrow 0.8 mm pitch. We therefore recommend reflow soldering. 11-2 Cleaning 1. Residual flux after board washing may cause solder migration. Carefully check the status of board washing. 2. Confirm they will not cause problems when they are not washed. 11-3 Others 1. This product has circuits on both sides. Do not use adhesives, because of concern that characteristics will be impaired by adhesives. 2. Do not use the products in dewy atmosphere. PAGE 8 OF 8 Bolivar Drive I P.O. Box 547 I Bradford, PA 16701 I USA I 814-362-5536 I Fax 814-362-8883 I www.koaspeer.com Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. |
Price & Availability of CR2A10YTE101101J
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |